Table of Contents
Advertisement
Sending Originals
D When sending to multiple des-
tinations, repeat steps B to C.
E Once all of the destinations are
specified, press [Exit].
Specified destinations are dis-
played on the second line of the
3
screen. If you specified multiple
destinations, press 0 or 1 to
view the other destinations.
E
Specify the sender (sender of the
original).
Note
❒ When a sender has been speci-
fied, this information is added
to the scan data file. When the
optional ScanRouter V2 Profes-
sional is used to send scan data
files as e-mail, the sender infor-
mation is automatically entered
in the message sender field.
❒ You can omit the sender. If you
do, the sender name will not ap-
pear in the sender column.
❒ You can only select one sender at
a time from the sender list regis-
tered on the delivery server.
A Press [Sender].
The short ID number and name
of the senders registered on the
delivery server appears.
38
B Highlight the name of the
sender.
If you know the short ID num-
ber of the sender you want to
send information to, enter it di-
rectly. If you do not know the
short ID number, press [↑ ↑ ↑ ↑ Prev.]
or [↓ ↓ ↓ ↓ Next] until the sender you
want appears, and then press 0
or 1 to highlight the sender.
C Press [Select].
The name you highlight is se-
lected as the sender and a '
mark appears in the check box
next to it. If you press [Deselect],
the selection is cancelled.
D Press [Exit].
F
Make original orientation set-
tings.
If originals are set in an upright ( )
position, perform the following
procedure to change the original
orientation settings when perform-
ing duplex scans.
A Press [R
R
R
R
↔ R
↔ ↔
↔
R
R
R
1
].
2
Advertisement
Table of Contents
