Table of Contents
Advertisement
Scanner Configuration
This section describes the settings
necessary for this scanner's scanner
function.
Settings
❖ ❖ ❖ ❖ Function Priority
You can choose between "TWAIN"
o r " D e l iv e r y " , d e p e n d i n g o n
whether you want the Network
TWAIN scanner mode or the net-
work delivery scanner mode to
start when the scanner is turned
on.
The factory default is "Delivery".
Note
❒ If you select "TWAIN", the scan-
ner starts in Network TWAIN
scanner mode when it is turned
on. You can switch back to the
network delivery scanner mode
by pressing [Cancel].
❒ If you select "Delivery", this
scanner starts in network deliv-
ery scanner mode when the
power is turned on. However,
you cannot switch from the net-
work delivery scanner mode to
the Network TWAIN scanner
mode. If you want to use the
scanner as a Network TWAIN
scanner, access the scanner
from a client computer that can
perform scans.
Important
❒ When changing this setting, be
sure to restart the scanner to ap-
ply the change.
❖ ❖ ❖ ❖ TWAIN Connection Timeout
The length of time after which the
scanner can switch modes can be
set for when the scanner is used as
a network delivery scanner and
another client accesses the scanner
to use as a network TWAIN scan-
ner.
• If you select "Immediate", the
scanner immediately switches
to network TWAIN scanner
mode.
• If you select "On", enter the
length of the interval, in sec-
onds (3 to 30).
The factory default is "Immediate".
❖ ❖ ❖ ❖ Scanner Auto Reset Timer
If the scanner remains idle for a
certain amount of time, a sender's
address, name and scan condi-
tions, set in the network delivery
scanner mode, are deleted. You
can set the length of time after
which the scanner performs this
task.
• If you select "On", enter the
length of time, between 10 and
999 seconds, after which the set-
tings are deleted.
• If you select "Off", the settings
are not deleted.
The factory default is "Off".
Note
❒ If the scanner automatic clear
function is active, the sender's
address, name, and scanning
conditions are cleared after the
specified number of seconds.
Further, the display returns to
the "Function Priority" screen.
Scanner Configuration
23
2
Advertisement
Table of Contents
