Table of Contents
Advertisement
Initial Scanner Setup
D
Press [↑ ↑ ↑ ↑ Prev.] or [↓ ↓ ↓ ↓ Next] until the
item you want to set appears, then
press [OK].
2
E
Make the necessary settings.
Example: image density setting
Example: resolution setting
• When you need to enter values,
enter the digits with the number
keys. If you press the {#} key af-
ter you have entered informa-
tion, you can enter values in the
next column. You can change
the input position by pressing
0 or 1.
• To scroll up or down the list of
settings, press [↑ ↑ ↑ ↑ ] or [↓ ↓ ↓ ↓ ] until
the item you want to set ap-
pears.
Note
❒ For more details about the con-
tent of each setting, see P.17
"Settings".
❒ If you want to cancel a setting,
press [Cancel]. The setting is not
changed, and the screen returns
to the display that appeared be-
fore you pressed [OK].
❒ An "*" mark appears with the
current setting.
20
F
Repeat steps D D D D to E E E E and set the
next item.
Reference
For details on the operation
when Scan size is "Custom
Size", see P.20 "Customizing the
Scan Size".
G
When all your settings are done,
press [PrevMenu].
The display returns to the step B
screen.
Note
❒ You can make "Network Setup"
and "Config." settings from this
display.
H
Press [Exit].
The new settings are saved and the
display returns to the screen that
was displayed before you started
making settings.
Customizing the Scan Size
If you select "Custom Size" as your
scan size, you can specify the dimen-
sions of the scan area in millimeters or
inches.
Note
❒ Select the measurement units in
"Configuration" in Scanner Fea-
tures.
A
Display "Custom Size" in the
Scan size selection screen, and
press [OK].
Advertisement
Table of Contents
