Throttle Off (Engine Cut) "Thoff - FUTABA 4PL-2.4GHZ Instruction Manual

Throttle off (engine cut) "THOFF"

This is a function select switch function. The throttle off function ON/OFF switch must
be set. The engine cut function stops the engine of a boat, etc. by operating the throttle
servo to the slow side by switch regardless of the position of the throttle trigger and the
setting of other functions (reverse function setting is effective).
Dial / Trim Setting
The function select dial function can control the throttle-off position can be controlled
with digital dial or digital trim. (See page 60)
Operation display
An LED blinks while the neutral brake function is active.
< NO SW >
I f f u n c t i o n 's O N / O F F
switch is not selected,
<NO SW> is displayed.
The function select switch
screen (P62) can be dis-
played from this screen.
Engine Cut function adjustment
(Preparation)
- Use the function select switch to select the switch. (page 62)
1
(Preset position setup)
- Select the setting item "THOFF" by (UP) or (DN) button.
Use the (+) and (-) buttons to set the preset position of the
throttlle servo.
2
When ending, return to the ADVANCE menu screen by
pressing the (CT) button.
Caution
Always operate carefully before using this function.
While switch with preset function set is in the ON state, the servo (motor controller) is locked in the preset posi-
tion and does not operate even if the throttle trigger is operated. If the servo was operated at the wrong setting,
you may lose control of the car (boat).
If the power switch is
t u r ned on wh ile t he
throttle-off switch is on,
an audible alarm will be
heard. Immediately set
the neutral brake switch
to OFF.
Throttle Mode "THR MODE"
Warning display
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Preset position (THOFF)
0 ~ B100
Initial value: 0
81