Initial Set-Up; Preparations (Transmitter) - FUTABA 3PKS Instruction Manual

Before setting the Transmitter functions, check and set items 1 to 4 below.
(Display when power switch turned on)
When the power switch is turned on, the currently selected model number is displayed.
Check of this number is model number you want to setup. To change the model number,
use the Model Select function (See page98).
1.RF Output Check
If signals are output normally, RF output monitor "RF" will
be displayed on the screen.
If "RF" is not displayed, check if the transmitter crystal and
RF module are installed.
If the transmitter is abnoemal or faulty, contact your Futaba
dealer.
Instal set-Up

Preparations (Transmitter)

Turn on the transmitter power.
(Start screen)
The model number is displayed.
"RF"
When radio waves are not being emitted
when turned on by display switch and
when the DSC function is used, "DISP" is
displayed.
33