Terminating A Conference Call - Mitel IP8630M Operation Manual

5. When the called party answers the call the second party is still on hold, and the conversation is
only between the third party and the first party, i.e. initiator of the conference.
6. To start conversation between the three parties – i.e. a conference – press the middle softkey
"Conf."
7. The "Conference" screen as seen above will then be displayed, and the three participants will
be in a conference call. Thereby the conversation is between all three parties.
NOTE 1: It is possible to invite more participants to the conference by repeating the steps 2. – 6. for
one of the participants in the conference that has not yet invited a party to the conference. Once a
participant has invited a new party to the conference it is not possible for this participant to invite new
parties to the conference.
NOTE 2: The maximal amount of participants to participate in a conference call is set according to the
number of bases in a system. On a system with two bases it should be possible to have 10 participants
in a conference call.

7.7.2 Terminating a Conference Call

When a conference call is terminated it is dependent of which participant that terminates it, if the
whole conference is terminated, or if the conference is ongoing between the two participants left in
the conference.
Option 1
1. The user who has started the conference presses the red "On-hook" key
the conference call.
2. The whole conference is terminated, and none of the participants continue to be in call.
Option 2
1. One of the participants that have been invited to the conference presses the red "On-hook"
key to terminate the conference call.
2. The call is only terminated for the participant that terminated the call
3. There is still an ongoing call between the initiator of conference, and the participant that have
not ended the call.
Version 1.4
to terminate
Page | 74