How To Set: Water Hardness; Daily Use - Electrolux SteamBoost 800 Series User Manual

DAILY USE

5.4 How to set: Water hardness

When you connect the oven to the mains you have to set the water hardness level.
Use the test paper supplied with the steam set.
Step 1
Put the test paper
into water for about
1 sec. Do not put
the test paper under
running water.
The colours of the test paper continue to change. Do not check water hardness later than 1
min after test.
You can change the water hardness level in the menu: Settings / Setup / Water hardness.
The table shows water hardness range (dH) with the corresponding level of Calcium deposit
and the water classification. Adjust the water hardness level according to the table.
Water hardness
Level dH
1 0 - 7
2 8 - 14
3 15 - 21
4 ≥22
When the tap water hardness level is 4, fill the water drawer with still bottled water.
6. DAILY USE
WARNING!
Refer to Safety chapters.
146/576
Step 2
Shake the test paper
to remove the excess
of water.
Test paper
Step 3
After 1 min, check
water hardness with
the table below.
Calcium de‐ Calcium de‐
posit (mmol/l) posit (mg/l)
0 - 1.3
1.4 - 2.5
2.6 - 3.8
≥ 3.9
Step 4
Set the water hardness
level: Menu / Settings /
Setup / Water hard‐
ness.
Water classi‐
fication
0 - 50 soft
51 - 100 moderately
hard
101 - 150 hard
≥151 very hard