Lamp Replacement
5
Install the new Lamp unit.
Remove the Lamp ET-LA059 from the LCD
Projector and install a new lamp unit
(ET-LA059.)
• Do not drop, impact of dropping may cause Lamp to
explode.
6
Replace the Lamp unit screws.
Replace the Lamp unit screw and the Lamp cover
screws using a screwdriver to tighten.
• Properly dispose of old Lamp.
Note
• Attach the lamp unit and lamp unit housing door securely. If
the lamp unit and lamp unit housing door are not attached
securely, the protective circuit will be activated and the
power will not turn on.
7
Plug the LCD Projector back in by inserting the
Power cord in LCD Projector AC socket and
set the Main Power Switch to ON.
8
For lamp replacement, please see the included
separate sheet to perform the reset procedure.
Lamp unit
Screw driver
Lamp cover
screw
52