Table of Contents
Advertisement
Before using the Remote Control
Load the 2 "AA" batteries in the Remote Control
1
Slide the lid in the direction of the arrow.
2
Install 2 "AA" batteries as indicated inside the Battery Compartment.
Battery replacement caution
• Do not mix old and new batteries.
Also never mix alkaline with manganese batteries.
3
Replace the lid and snap into place.
Using the Laser Pointer on the Remote Control
When the Laser beam is aimed at the screen, the Pointer is displayed on the screen.
transmitter
Laser
DO NOT look into the Laser transmitter, or aim the
Warning
Laser beam at a person. Shining the Laser beam into
the eyes could result in eye damage.
Note
• This product has the following laser radiation specifications:
Wavelength - 650 nm, Max. Output - 1 mW, Class (Class 2.)
For U.S.A. only
• Class laser products are normally required to be equipped with an
indicator indicating that the laser beam is being emitted. On this product,
the red beam emitted from the laser point functions as this indicator.
• Class laser products are normally required to be equipped with an
emergency stop device such as a shutter to stop the laser immediately. On
this product, instead of such a device, the laser does not stay on unless
the laser button is held in continuously.
CAUTION: Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
Press and hold LASER on the remote control to
activate Laser.
2 "AA" Batteries (included)
10
Advertisement
Table of Contents
