Table of Contents
Advertisement
Basic LCD Projector Operation
Adjusting the Volume
The volume can be adjusted using the VOLUME +/- buttons on the LCD Projector or remote control.
V
o
l
u
m
e
+
2
4
Turning off the sound
If the MUTE button on the remote control is pressed, "Mute" will be displayed on the screen as shown in the illustration
below and the sound will be muted. If the MUTE button is pressed again, the normal sound volume will be restored.
M
u
t
e
Turning off the Picture and Sound at the same time
When SHUTTER button is pressed on the remote control the picture and sound turns off and the screen goes black,
Press SHUTTER button again to resume picture and sound.
Black screen
Freezing the picture
Projection can be switched between a frozen (still) picture and a moving picture each time when the FREEZE button on
the remote control is pressed. Press FREEZE button again to resume motion.
F
r
e
e
z
e
• Press VOLUME + button to turn the volume high.
(Remote Control
unit)
• Press VOLUME - button to turn the volume low.
Note
• The "Volume" will remain displayed on the screen for approximately
or
(LCD Projector)
(Remote Control
unit)
Note
• If the Power supply is turned off or either of the VOLUME +/-
(Remote Control
unit)
Note
• When the screen goes black, the picture will not be shown on
(Remote Control
unit)
Note
• The sound is muted while the picture frozen.
5 seconds.
buttons is pressed, the mute setting will be canceled.
the screen. However, the picture continues to be sent from the
Personal Computer or video source.
18
Advertisement
Table of Contents
