Safety Regulations For The Method Of Operation - Siemens FC2025 Manual

Safety Regulations for the Method of Operation

2.2
National Standards, Regulations and Legislation
Siemens products are developed and produced in compliance with the relevant United States
Coast Guard safety standards. Should additional national or local safety standards or legislation
concerning the planning, assembly, installation, operation or disposal of the product apply at the
place of operation, then these must also be taken into account together with the safety regulations
in the product documentation.
Electrical Installations
WARNING
Electrical voltage
Electric shock
● Work on electrical installations must be carried out by certified electricians or by
instructed persons working under the guidance and supervision of a certified
electrician, in accordance with the electrotechnical regulations.
Disconnect products from the power supply when carrying out commissioning, maintenance or

repair work on them.
Lock volt-free areas to prevent them being switch on again by mistake.

Label the connection terminals with external voltage using a 'DANGER External voltage' sign.

Route mains connections to products separately and fuse them with their own, clearly marked

fuse.
Fit an easily accessible disconnecting device in accordance with IEC 60950-1 outside the

installation.
Produce earthing as stated in local safety regulations.

Siemens Industry, Inc.
Building Technologies Division
Risk of Injury Is Presented
Information about the risk of injury is displayed:
WARNING
Nature and origin of the danger
Consequences if the danger occurs
● Measures / prohibitions for danger avoidance
How Possible Damage to Property is Presented
Information about possible damage to property is displayed:
NOTICE
Nature and origin of the danger
Consequences if the danger occurs
● Measures / prohibitions for danger avoidance
FS20 Marine Fire Detection Control Panel
15
A6V10519176_enUS_b