Console Service Mode - Schwinn AD7 AirDyne Service Manual

Console Service Mode

The Console Service Mode lets you see the total time and distance the machine has been used, adjust the altitude value
for a more accurate calorie count, or find out which version of Firmware is installed.
1. Hold down the STOP/RESET button and Decrease () button together for 3 seconds while in the Idle Mode to go into
the Console Service Mode.
2. The Console display shows the machine statistics:
• Total Machine Time—number of hours (in Time/Interval field). Maximum display is 9999.
• Total Machine Distance—number of miles in 10-mile increments (in cumulative metrics field). Display cycles MI for 5
seconds, then KM for 5 seconds.
3. Push STOP/RESET to exit Console Service Mode. Push the Decrease button to go to the next option.
4. The Console display shows CAL (calibration). To calibrate the machine, refer to the "Calibration Procedure" section.
Push the Decrease button to go to the next option.
5. The Console display shows the Firmware Version.
6. Push STOP/RESET to exit Console Service Mode.
In Service Mode if the Console does not receive any input in approximately 5 minutes, it goes into Sleep Mode.
9