Install A Hot-Swap Power Supply - Lenovo ThinkSystem ST250 V2 Setup Manual
Hide thumbs
Also See for ThinkSystem ST250 V2:
- Quick start (2 pages) ,
- Maintenance manual (260 pages) ,
- Reference (200 pages)
Table of Contents
Advertisement
Figure 27. Removing the front bezel
Install a hot-swap power supply
Use this information to install a hot-swap power supply.
About this task
To avoid potential danger, read and follow the following safety statements.
• S001
DANGER
Electrical current from power, telephone, and communication cables is hazardous.
To avoid a shock hazard:
– Connect all power cords to a properly wired and grounded electrical outlet/source.
– Connect any equipment that will be attached to this product to properly wired outlets/sources.
– When possible, use one hand only to connect or disconnect signal cables.
– Never turn on any equipment when there is evidence of fire, water, or structural damage.
– The device might have more than one power cord, to remove all electrical current from the
device, ensure that all power cords are disconnected from the power source.
ThinkSystem ST250 V2 Setup Guide
70
Advertisement
Table of Contents
