Dhcp - Planet Networking & Communication LCG-300 Series User Manual

4.5.13

DHCP

The DHCP service allows you to control the IP address configuration of all your network devices. When
a client (host or other device such as networked printer, etc.) joins your network it will automatically get
a valid IP address from a range of addresses and other settings from the DHCP service. The client
must be configured to use DHCP; this is something called "automatic network configuration" and is
often the default setting. The setup is shown in
Object
DHCP Service
Start IP Address
Maximum DHCP Users
Set DNS
Primary/Secondary DNS
Figure 4-5-9.
Figure 4-5-9: DHCP
By default, the DHCP Server is enabled, meaning the LoRaWAN
Gateway will assign IP addresses to the DHCP clients
automatically.
If user needs to disable the function, please set it as disable.
By default, the start IP address is 192.168.1.100.
Please do not set it to the same IP address of the LoRaWAN
Gateway
By default, the maximum DHCP users are 101, meaning the
LoRaWAN Gateway will provide DHCP client with IP address from
192.168.1.100 to 192.168.1.200 when the start IP address is
192.168.1.100.
By default, it is set as Automatically, and the DNS server is the
LoRaWAN Gateway's LAN IP address.
If user needs to use specific DNS server, please set it as Manually,
and then input a specific DNS server.
Input a specific DNS server.
- 74 -
Industrial LoRaWAN Gateway
Description
LCG-300 series