Planet Networking & Communication LCG-300 Series User Manual page 103

Object
IPSec Tunnel Enable
Tunnel Name
Interface
Local Network
Local Netmask
Remote IP Address
Remote Network
Remote Netmask
Dead Peer Detection
Preshare Key
IKE
Connection Type
Check the box to enable the function.
Enter any words for recognition.
This is only available for host-to-host connections and specifies to
which interface the host is connecting.
1. WAN 1.
2. WAN 2.
The local subnet in CIDR notation. For instance, "192.168.1.0".
The netmask of this LoRaWAN Gateway
Input the IP address of the remote host. For instance, "210.66.1.10".
The remote subnet in CIDR notation. For instance, "210.66.1.0".
The netmask of the remote host.
Set up the detection time of DPD (Dead Peer Detection).
By default, the DPD detection's gap is 30 seconds, over 150 seconds
to think that is the broken line.
When VPN detects opposite party reaction time, the function will take
one of the actions: "Hold" stand for the system will retain IPSec SA,
"Clear" stand for the tunnel will clean away and waits for the new
sessions, "Restart" will delete the IPSec SA and reset VPN tunnel.
Enter a pass phrase to be used to authenticate the other side of the
tunnel. Should be the same as the remote host.
Select the IKE (Internet Key Exchange) version.
1. Main.
2. Aggressive.
- 103 -
Industrial LoRaWAN Gateway
Description
LCG-300 series