Rip - Planet Networking & Communication LCG-300 Series User Manual

Routing tables contain a list of IP addresses. Each IP address identifies a remote LoRaWAN Gateway
(or other network gateway) that the local LoRaWAN Gateway is configured to recognize. For each IP
address, the routing table additionally stores a network mask and other data that specifies the
destination IP address ranges that remote device will accept.
Object
Type
Destination
Net Mask
Gateway
Interface
Comment
4.5.9

RIP

Please refer to the following sections for the details as shown below.
There are two types: Host and Net.
When the Net type is selected, user does not need to input the
Gateway.
The network or host IP address desired to access.
The subnet mask of destination IP.
The gateway is the router or host's IP address to which packet was
sent. It must be the same network segment with the WAN or LAN
port.
Select the interface that the IP packet must use to transmit out of the
router when this route is used.
Enter any words for recognition.
Figure: OSPF Configuration table
- 71 -
Industrial LoRaWAN Gateway
Description
LCG-300 series