Chapter 4. Web-Based Management; Introduction; Logging In To The Lorawan Gateway - Planet Networking & Communication LCG-300 Series User Manual

Chapter 4.
This chapter provides setup details of the device's Web-based Interface.
4.1

Introduction

The device can be configured with your Web browser. Before configuring, please make sure your PC is
under the same IP segment with the device.
4.2

Logging in to the LoRaWAN Gateway

Refer to the steps below to configure the LoRaWAN Gateway:
Connect the IT administrator's PC and LoRaWAN Gateway's LAN port (port 1) to the same
Step 1.
hub / switch, and then launch a browser to link the management interface address which is
set to http://192.168.1.1 by default.
The DHCP server of the LoRaWAN Gateway is enabled. Therefore, the
LAN PC will get IP from the VPN LoRaWAN Gateway If user needs to set
IP address of LAN PC manually, please set the IP address within the range
between 192.168.1.2 and 192.168.1.254 inclusively, and assigned the
subnet mask of 255.255.255.0.
The browser prompts you for the login credentials. (Both are "admin" by default.)
Step 2.
Default IP address: 192.168.1.1
Default user name: admin
Default password: admin
Default SSID (2.4G): PLANET_2.4G (LCG-300W only)
Default SSID (5G): PLANET_5G (LCG-300W only)
Administrators are strongly suggested to change the default admin and
password to ensure system security.
Web-based Management
- 35 -
Industrial LoRaWAN Gateway
LCG-300 series