Removing The M.2 Ssd Module - Dell PowerEdge XR4520c Installation And Service Manual

Figure 54. Installing the BOSS-N1 card
Next steps
After working inside your

Removing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the BOSS-N1
Steps
1. Using the Phillips 1 screwdriver, remove the screw that secures the M.2 SSD module to the BOSS-N1 card.
2. Pull the M.2 SSD module to disconnect from the connector on the BOSS-N1 card.
Figure 55. Removing the M.2 SSD module
Next steps
If applicable, Install the BOSS-N1
system.
Safety instructions.
Before working inside your
card.
card.
system.
Installing and removing system components 87