Table of Contents
Advertisement
3.
Remove the
sled.
4. Disconnect the riser card power cable from the power interposer board.
NOTE:
Observe the routing of the cable as you remove it from the system.
Steps
1. Using the Phillips 2 screwdriver, loosen the three captive screws that secure the riser 1C on the 2U sled.
2. Using the Phillips 1 screwdriver, remove the screw that secures the riser 1C to the fix hook of the 2U sled.
3. Hold the expansion card riser 1C by the edges and lift the expansion card riser from the riser connector on the 2U sled.
Figure 31. Removing the expansion card riser 1C
Next steps
Replace the expansion card
Installing the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the
sled.
Steps
1. Align the riser card with the riser slot on the 2U sled.
2. Using both hands, lower the riser 1C card until it is seated firmly.
3. Using a Phillips 2 screwdriver, tighten the three captive screws and using a Phillips 1 screwdriver tighten the screw to secure
the expansion card riser 1C on to the 2U sled.
70
Installing and removing system components
riser.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
