Figure 57. Removing the M.2 riser
Next steps
Replace the M.2
Riser.
Installing the M.2 riser module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Align the M.2 module with the system board and insert it firmly using the blue touch point until the riser is fully seated in the
slot.
2. Using a Phillips 2 screwdriver, tighten the two screws to secure the riser to the system board.
Figure 58. Installing the M.2 riser
Safety
instructions.
Before working inside your
system.
Installing and removing system components
89