Table of Contents
Advertisement
Figure 22. Removing the 2U sled from the 1U sled
Next steps
Replace the 2U floor on the 1U
sled.
Installing the 2U sled on the 1U sled
Prerequisites
1. Follow the safety guidelines listed in
Safety
Instructions.
2. Follow the procedure listed in
Before working inside your
system.
Steps
1. Align the 2U sled horizontally and place it on top of the 1U sled such that, the INT signal cable passes through the 1U sled.
CAUTION:
Support the 2U node with both hands while placing it on the 1U sled.
2. Using the Phillips 1 screwdriver, tighten the screws on two sides of the system that secure the 2U floor on the 1U sled.
Installing and removing system components
61
Advertisement
Table of Contents
