Figure 20. Removing the 2U side cover
Next steps
Install the 2U sled on the 1U
Installing the side cover
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the
sled.
Steps
1. Align the side cover with the slot on the 2U sled.
2. Using a Phillips 2 screwdriver, tighten the captive screw to secure the 2U side cover.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
sled.
Safety
Instructions.
Before working inside your
system.
Installing and removing system components
59