Figure 60. Installing the M.2 SSD module
Next steps
1.
Installing the M.2 riser
2. Follow the procedure listed in the
Network I/O board
Removing the Network I/O board
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Using the Phillips 2 screwdriver, loosen the blue thumbscrew.
CAUTION:
Follow the guiding pin to prevent damage to the Network I/O board.
2. Disconnect the Network I/O board signal cable connected on the system board.
NOTE:
Observe the routing of the cable as you remove it from the system.
3. Disconnect the Network LED RAF or NAF signal cable from the Network I/O board. To disengage the Network I/O board
from the slots on the chassis, slide the Network I/O board towards the rear of the system.
module.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
91