Figure 19. Installing the power interposer board
Next steps
Install the expansion card riser
2U sled
This is a service technician replaceable part only.
Removing the side cover
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the
sled.
Steps
1. Using the Phillips 2 screwdriver, loosen the captive screw that secures the side cover to the 2U sled.
2. Slide the side cover outward to remove it from the sled.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
58
Installing and removing system components
1C.
Safety
Instructions.
Before working inside your
system.