Installing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Align the M.2 SSD module connector with the connectors on the BOSS-N1 card.
2. Push the M.2 SSD module until the module is seated firmly on the BOSS-N1 card and secure it by installing the screw.
Figure 56. Installing the M.2 SSD module
Next steps
Follow the procedure listed in the
M.2 riser module
Removing the M.2 riser module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Using a Phillips 2 screwdriver, loosen the two captive screws that secure the M.2 riser.
2. Lift the riser using the blue touch point to disengage it from the connector on the system board.
88
Installing and removing system components
Safety
instructions.
Before working inside your
After working inside your
Safety
instructions.
Before working inside your
system.
system.
system.