TUAREG 660
•
Insert the safety plate (5).
Steering bearing
Adjusting play
To adjust the steering play, follow the procedure described below:
•
Place the vehicle so that the front wheel is off the ground.
•
Carry out a handlebar rotation test, using a dynamometer at the hand grip external end.
•
The handlebar resistance to rotation must be of 250 +/- 100 g (0.55 +/- 0.22 lb) in both
directions.
•
Adjust if clearance is detected.
NOTE
THE STEERING COLUMN RESISTANCE TO ROTATION MUST BE PERFORMED IN THE TWO
OPPOSITE ROTATION DIRECTIONS.
•
Remove the handlebars and upper
steering triple clamp.
Then proceed as described:
•
Remove the steering safety plate (1).
•
Remove the upper steering ring nut (2)
using the special tool.
Specific tooling
AP8140190 Steering tightening tool
Suspensions
SUSP - 149