Chassis
•
Using a pin with adequate dimensions
(length greater than 350 mm and di-
ameter less than/equal to 30 mm),
push the swingarm pin from left to right
out of its seat so that the pin used re-
places the swingarm pin.
•
Take care to collect the spacers (14) on
both sides
•
Unscrew the two fixing screws (15) of
the rear brake switch to remove the
right support plate (16).
PASSENGER FOOTRESTS
THE OPERATIONS DESCRIBED BELOW RE-
FER TO A SINGLE FOOTREST, BUT ARE VAL-
ID FOR BOTH
•
Remove the split pin (1) of the pin and
the washer (2).
CAUTION
ALWAYS USE A NEW SLIT PIN DURING REASSEMBLY .
•
Remove the pin (3).
CHAS - 210
TUAREG 660