Front Brake Disc Inspection - APRILIA TUAREG 660 Service Station Manual

TUAREG 660
•
Remove the tone wheel (2) (if applica-
ble).
•
Remove the brake disc (3).
Disc Inspection
•
The following operations must be car-
ried out with the brake discs fitted on
the wheel; they refer to a single disc,
but are valid for both.
•
Check the disc for wear by measuring
the minimum thickness with a micro-
meter in different points. If the mini-
mum thickness, even in a single point
of the disc, is less than the minimum
value, replace the disc.
Disc thickness minimum value: 4 mm (0.16 in)
•
Using a dial gauge, check that the max-
imum oscillation of the disc does not
exceed the tolerance; otherwise, re-
place it.
Disc oscillation tolerance: 0.15 mm (0.0059 in)
Braking system
BRAK SYS - 247