Front Brake Pump Installation; Rear Brake Pump Removal - APRILIA TUAREG 660 Service Station Manual

Braking system
Removal
To remove the front brake master cylinder it is
necessary to previously drain the front system, re-
move the rear view mirror and handguard com-
plete with support. Then proceed as described:
•
Remove the rubber grommets that fas-
ten the brake line to the wiring harness.
•
Unscrew the fixing screw of the brake
line complete with the two washers.
•
Unscrew the two fixing screws of the U-
bolt to completely remove the brake
master cylinder.
Installing
To install the front master cylinder, carry out the procedures described above in reverse order. Then fill
the system and bleed it.
PAY ATTENTION TO USE NEW WASHERS TO FASTEN THE SCREW OF THE BRAKE LINE.
Rear brake pump
BRAK SYS - 256
TUAREG 660