TUAREG 660
•
Remove the lower seat of the bearing
(10) using a standard bearing extractor
To remove the lower steering bearing:
•
After removing the inner bearing ring
(11) complete with balls from the head-
stock tube, heat the lower bearing seat
(12) with a hot air gun to remove it and
then slide off the dust cover (13).
•
Remove the upper seat of the lower
bearing (14) from below using a stand-
ard bearing extractor.
DURING THE INSTALLATION OF THE BEARINGS, IT IS NECESSARY TO GREASE THEM BE-
FORE INSERTING THEM IN THE STEERING HEADSTOCK.
Assembling
To assemble the steering assembly, proceed as
described:
•
Place the dust cover (1) on the steering
headstock.
•
Insert the lower seat of the bearing (2)
and the inner ring of the bearing (3)
complete with balls, sprinkling them
with grease
Suspensions
SUSP - 153