8 MAINTENANCE AND LUBRICATION
8.3
LUBRICATION OF CUTTING UNITS AND LIFT ARMS _____________________
1
Lubricate the cutting Units and lift arm pivots as per service schedule. Grease point locations can be found at the
following locations.
Front Pivot Arm (A), Centre Pivot Arm (B)
C
D
Cutting Unit Mounting (C). Bearing Housings (D) and Rear Rolls (E) are located both ends of unit.
Magna 250 Unit
Cutting Unit Drive Splines (F) - Cylinder and Flail drive Shaft ends (Flail illustrated)
en-82
A
C
D
E
F
C
MT Flail Unit
F
B
D