Table of Contents
Advertisement
6 CONTROLS
6.5.5 ADAPTICUT™ ______________________________________________________
TM
AdaptiCut
is a load sensing system that maintains optimum cutting
performance by adjusting ground speed depending on the machine cutting
system loading. It will automatically activate when the vehicle transmission
is set to Automatic (A), the speed is set to Mow (Cutter Switch is on),
Cruise is active, and the cutting system detects increased load. When
TM
active the AdaptiCut
Cutting Unit Position lamps on the armrest pod will turn red.
The rate at which the vehicle speed is reduced or increased in relation to
cutter system loading can be adjusted via the display as follows:
1. Press Button 4 twice to enter the Main Menu
2. Use Button 3 to scroll to Settings followed by Button 4 to enter the
Settings Menu
3. Use Button 3 to scroll to PIN followed by Button 4 to enter the Enter
PIN page
4. Enter the Owner PIN (Default 1001) to enter the PIN Menu page
5. Use Button 3 to scroll to AdaptiCut
TM
the AdaptiCut
6. Use Button 2 & 3 to select either Speed Decrease or Speed
Increase as necessary, followed by Button 4 to select
7. Use Button 1 to 4 to adjust the parameters as desired. Note that
once the desired settings have been adjusted the screen will auto-
matically save the settings and return to the previous screen if no
buttons are pressed for 3 seconds.
6.5.6 VEHICLE SPEED ____________________________________________________
The vehicle forward and reverse transmission speeds are factory set to the
defaults stated in this manual however can be adjusted via the display as
follows:
1. Press Button 4 twice to enter the Main Menu
2. Use Button 3 to scroll to Settings followed by Button 4 to enter the
Settings Menu
3. Use Button 3 to scroll to PIN followed by Button 4 to enter the Enter
PIN page
4. Enter the Owner PIN (default 1001) to enter the PIN Menu page
5. Use Button 3 to scroll to Vehicle Speed followed by Button 4 to
enter the Vehicle Speed settings screen
6. Use Button 2 & 3 to select the speed to be adjusted followed by But-
ton 4 to select
7. Use Button 2 & 3 to increase or decrease as desired, followed by
Button 4 to save
8. Adjust the other speeds as necessary or use Button 1 to exit
en-48
icon will be displayed on the screen and the green
TM
followed by Button 4 to enter
adjustment page
Advertisement
Table of Contents
