Table of Contents
Advertisement
To disengage Cruise, Use one of the two methods below:
• Put foot back onto the Forward/Reverse pedal and push the pedal forwards. Note in this scenario the machine
will continue to drive forwards.
• Press and release the Cruise Control switch. Note in this scenario the machine will come to a stop.
Cruise will also disengage if the Forward/Reverse pedal is moved backwards to brake.
DISABLING CRUISE
Cruise can be disabled via the display as follows:
1. Press Button 4 twice to enter the Main Menu
2. Use Button 3 to scroll to Settings followed by Button 4 to enter the
Settings Menu
3. Use Button 3 to scroll to PIN followed by Button 4 to enter the Enter
PIN page
4. Enter the Owner PIN (default 1001) to enter the PIN Menu page
5. Use Button 3 to scroll to Cruise Control followed by Button 4 to enter
the Cruise Control settings screen
6. Use Button 2 & 3 to select either Enabled or Disabled as necessary,
followed by Button 4 to set
7. Button 1 is then used to exit to the Main Menu or Home Screen
6.5.4 PIN________________________________________________________________
Enter Pin
1 0 0 1
_ _ _ _
This screen gives access to the following parameters and machine functions that can be altered:
• Cross Cut
• Traction Boost
• Inclinometer
• Set Default Parameters
• Change PIN
• Flail \ Cylinder Mode
The default owner's Pin is 1001, however Ransomes Jacobsen recommend this is changed
Enter Pin
Enter Pin
CONTROLS 6
PIN Menu
Cross Cut
Traction Boost
Inclinometer
Set Default Parameters
Change PIN
en-47
Advertisement
Table of Contents
