Table of Contents
Advertisement
6 CONTROLS
6.2.I
CRUISE CONTROL SWITCH ___________________________________________
Cruise Control function will only operate whilst in cutting mode.
When selected it will automatically hold the desired vehicle
speed until further input by the operator is made.
To engage cruise control:
Automatic mode should be selected to enable cruise control.
Press the rocker switch to engage the cruise function.To disen-
gage cruise control press the rocker switch to disengage the
cruise function. The cruise control icon shall be displayed when
active.
6.2.J TRANSPORT LOCK SWITCH __________________________________________
Engages the front Cutting Unit lift arm locks for transport, pre-
venting unintentional lowering of the cutting units whilst driving.
Press the forward part of the rocker switch to engage. Press the
rear part of the switch to disengage.
The wing unit lock icon is displayed on the visual display screen
when engaged.
6.3
VISUAL DISPLAY _____________________________________________________
The visual display is activated when the ignition is turned on.
6.3.1 STARTUP SCREEN __________________________________________________
When the Ignition Key is turned to the start position, this screen is shown.
The Hour Meter will show total hours of engine operation.
6.3.2 WARNING / SERVICE SCREEN_________________________________________
After the Start-up Screen the Warning Screen is
shown, the screen is visible for four seconds. If the
machine is within 5 hours of the next service, a
warning is shown. An operator input is needed to
continue to the Home Screen. If there is no input
needed, the main screen will become visible. If a
fault condition has occurred during the previous
start, a pop up screen will become visible over the
top of the warning screen. The operator must
confirm the fault before they can move to the Home
Screen.
en-34
WARNING
If incorrectly used this machine can cause
severe injury. Those who use and maintain
this machine should be trained in its proper
use, warned of its dangers and should
read the entire operators manual before
attempting to set up, operate,
adjust or service
the machine.
2.5 Hours
®
1234
123.4 Hours
P
TM
Advertisement
Table of Contents
