Table of Contents
Advertisement
The default, minimum and maximum allowable speeds are shown in the table below:
Note all speeds can be incremented by 1 km/h.
6.5.7 FLAIL \ CYLINDER MODE _____________________________________________
The MT503 cutting system is capable of providing power to both Magna 250 cutting cylinders and MT Series flail
units. To ensure that these run at their intended speed it is important to ensure the machine's cutting system is
configured correctly.
The cutting system mode can be selected via the display as follows:
1. Press Button 4 twice to enter the Main Menu
2. Use Button 3 to scroll to Settings followed by Button 4 to enter the
Settings Menu
3. Use Button 3 to scroll to PIN followed by Button 4 to enter the Enter
PIN page
4. Enter the Owner PIN (default 1001) to enter the PIN Menu page
5. Use Button 3 to scroll to Flail \ Cylinder Mode followed by Button 4
to enter the Flail \ Cylinder Mode settings screen
6. Use Button 2 & 3 to select the required mode as appropriate followed
by Button 4 to set
7. Button 1 is then used to exit to the Main Menu or Home Screen
6.5.8 LIFT ON REVERSE___________________________________________________
The cutting units will automatically lift to the Cross Cut position while mowing and the vehicle is moved in reverse.
Lift On Reverse can be disabled via the display as follows:
1. Press Button 4 twice to enter the Main Menu
2. Use Button 3 to scroll to Settings followed by Button 4 to enter the
Settings Menu
3. Use Button 3 to scroll to PIN followed by Button 4 to enter the Enter
PIN page
4. Enter the Owner PIN (default 1001) to enter the PIN Menu page
5. Use Button 3 to scroll to Lift On Reverse followed by Button 4 to
enter the Lift On Reverse settings screen
6. Use Button 2 & 3 to select either Enabled or Disabled as neces-
sary, followed by Button 4 to set
7. Button 1 is then used to exit to the Main Menu or Home Screen
Forwards
Transport
Reverse
Forwards
Mow
Reverse
Forwards
Creep
Reverse
Default
Min
Max
(km/h)
(km/h)
(km/h)
25
1
8
1
13
1
6
1
8
1
5
1
CONTROLS 6
25
13
16
13
10
10
en-49
Advertisement
Table of Contents
