F
Operations
Powering on the Receiver
To power on the DTP2 R 212 receiver:
1.
2.
3.
4.
Selecting an Input
To switch an input to the output, you have the following options:
•
Output — Lights when an active sink (output) device is connected to the HDMI
•
output.
HDCP status LEDs (see
figure 13
•
Inputs — Each input has a corresponding HDCP LED. If the connected source
requires HDCP, the corresponding LED lights when authentication is successful.
NOTE: HDCP is authenticated on each input regardless of the currently
selected source.
•
Output — Lights if the currently selected input requires HDCP and the connected
output device has been successfully authenticated.
NOTE: HDCP is re‑authenticated on the output whenever a new input is
selected.
NOTE: All front panel LEDs flash three times simultaneously when Executive Mode
(front panel lockout) is enabled or disabled via SIS Commands (see
Lockout (unsolicited)
File).
Connect all input and output devices to the rear panel ports on the receiver (see
Panel Features
on page 7 for the rear panel connections).
Power on the display.
Power on the DTP2 R 212 — Connect the power supply to the 2‑pole captive screw
power inlet on the receiver rear panel.
After approximately 4 seconds, the following happens:
The unit performs a self‑test, during which the front panel Auto Switch, Inputs,
•
Signal, and HDCP LEDs blink constantly. When the self‑test completes, the LEDs
blink once to indicate the receiver is fully functional.
•
The receiver reads the available EDID information from the connected output device
and writes it to memory on each input.
Power on the input devices.
Front panel buttons — Press the desired input button on the front panel (ensure auto‑
input switching is not enabled).
•
The appropriate front panel input LED lights to indicate the selected input.
•
The LED remains lit until a new input is selected.
Only one input can be switched to the output at a time.
•
NOTE: Buttons are disabled in auto‑switch mode, but LEDs still indicate the
selected input. For more information about auto‑input switching, see
Auto-Input Switching
on page 18) —
on page 43) or PCS (see the DTP2 R 212 PCS Help
on page 20
DTP2 R 212 Series • Operation
Front Panel
Rear
Enabling
19