Lan Connector Wiring; Tp Connector And Cable Recommendations - Extron electronics DTP2 R 212 Series User Manual

LAN Connector Wiring

See figure 7 for the LAN (Ethernet) wiring standard. Use this standard to terminate the LAN
cable with a RJ‑45 connector.
Use a straight‑through cable for connection to a switch, hub, or router.
•
• Use a crossover cable or a straight‑through cable for connection directly to a PC. Wire
the connector as shown in figure 7.
Pins:
1 2 3 4 5 6 7 8
Insert Twisted
Pair Wires
RJ-45
Connector
Figure 7.

TP Connector and Cable Recommendations

See figure 8 for the TIA/EIA T 568B wiring standard. Use this standard to terminate the
DTP2 cable with a RJ‑45 connector.
Side
Figure 8.
ATTENTION:
• Do not use Extron UTP23SF‑4 Enhanced Skew‑Free AV UTP cable or STP201
cable to link the DTP products or with DTP receivers or receivers. The DTP2 R 212
does not work properly with these cables.
• N'utilisez pas le câble audiovisuel Skew Free UTP version améliorée UTP23SF‑4
Extron ou le câble STP201 pour relier l'émetteur et le récepteur/sélecteur. Le
DTP2 R 212 ne fonctionne pas correctement avec ces câbles.
Supported cables
The DTP2 R 212 switcher is compatible with shielded twisted pair (STP) and unshielded
twisted pair (U/UTP) cable. However, Extron strongly recommends that you use STP cable
to achieve best performance.
Crossover Cable
(for direct connection to a PC)
End 1 End 2
Pin Wire Color Pin Wire Color
1 white-orange 1 white-green
2 orange 2 green
3 white-green 3 white-orange
4 blue 4 blue
5 white-blue 5 white-blue
6 green 6 orange
7 white-brown 7 white-brown
8 brown 8 brown
T568B T568A
A cable that is wired as TIA/EIA T568A at one
end and T568B at the other (Tx and Rx pairs
reversed) is a "crossover" cable.
LAN Connector Wiring
Pins:
RJ-45
1 2 3 4 5 6 7 8
Connector
TIA/EIA
T568B
Pin Wire color
1 White-orange
Orange
2
3 White-green
4 Blue
5 White-blue
6 Green
Insert
7 White-brown
Twisted
8 Brown
Pair Wires
TP Cable Termination
Straight-through Cable
(for connection to a switch, hub, or router)
End 1 End 2
Pin Wire Color Pin Wire Color
1 white-orange 1 white-orange
2 orange 2 orange
3 white-green 3 white-green
4 blue 4 blue
5 white-blue 5 white-blue
6 green 6 green
7 white-brown 7 white-brown
8 brown 8 brown
T568B T568B
A cable wired the same at both ends is called
a "straight-through" cable because no pin/pair
assignments are swapped.
DTP2 R 212 Series • Installation 13