Device Status Panel; Network Settings Panel - Extron electronics DTP2 R 212 Series User Manual

2. Edit the Device Name as desired.
3. When finished editing, click SAVE to confirm the changes or CANCEL to close the
window without making changes. Clicking the X in the upper‑right corner of the screen
also closes the window without saving the changes.

Device Status Panel

The Device Status panel displays the current date, time, time zone, the amount of time
the device has been running (Uptime), and the internal temperature in degrees Celsius.
To set the date and time:
1. Click EDIT (see figure 39 [left],
Settings panel opens to allow edits (right).
Figure 39.
2. Edit the Date/Time and Timezone as desired.
3. When finished editing, click SAVE to confirm changes or CANCEL to close the window
without making changes. Clicking the X in the upper‑right corner of the screen also
closes the window without saving the changes.
4. Alternatively, click Sync to PC (

Network Settings Panel

In the Network Settings
panel, set the IP address,
subnet mask, and gateway
address for the switcher, and
turn DHCP On and Off.
To set the IP addresses:
1. Click EDIT (see figure 40,
[left],
Settings panel. The
Network Settings panel
opens to allow edits
(right).
1
Device Status Panel
2
) in the Network
1
Figure 40.
) in the Device Status panel. The Device Status
) to set the date and time according to the PC.
Network Settings Panel
DTP2 R 212 Series • Internal Web Page 55