Extron electronics DTP2 R 212 Series User Manual page 52

Command
DTP Remote Power Status
View output remote power status
KEY: X2%
= Remote power:
EDID Minder
View/Read EDID in hex format
View EDID native resolution
KEY: X1@
= Current EDID information in hexadecimal format (128 or 256 bytes of hex data)
X1#
= Native resolution and refresh rate from selected EDID (example: 1920x1200 @ 60 Hz)
Verbose Mode
Set verbose mode
View verbose mode
NOTE: If tagged responses are enabled (modes 2 and 3) all read/view commands return the constant string and the value, as the
set command does.
KEY: X(
= Verbose mode
Device Name
Set unit name
Set name to factory default
View unit name
X&
KEY:
= Switcher name:
5 V Output Hot Plug Mode
Set output Hot Plug mode (5 V)
View output Hot Plug mode (5 V)
status
KEY: X2$
= 5 V output mode:
ASCII Command
(Host to Switcher)
E RPWR }
Verbose mode 2/3
0
= No remote power/Off
E R X! EDID }
E N X! EDID }
E X( CV }
E CV }
Verbose mode 2/3
0 1
= Clear/none (default) = Verbose mode
3
= Verbose mode and tagged responses for queries
E X& CN }
E }
•CN
E CN }
Verbose mode 2/3
The name can have up to 24 alphanumeric characters including hyphens (–), with no spaces. The first character
must be a letter, and the last character cannot be a hyphen. The default is
E M X2$ HPLG }
E MHPLG }
Verbose mode 2/3
1
= Auto (5 V enabled when source present with 5 V, otherwise off)
2
= 5 V always enabled (default)
Response
(Switcher to Host)
X2%]
Rpwr X2%]
1
= DTP2 48 VDC/On
X1@]
X1#]
Vrb X(]
X(]
Vrb X(]
2
= Tagged responses for queries,
X&
•
Ipn
]
Ipn•DTP2-R-212-xx-xx-xx] Model name followed by last
X&]
• X&]
Ipn
HplgM X2$]
X2$]
HplgM X2$]
DTP2 R 212 Series • SIS Commands
Additional Description
View remote power setting on
DTP2 In.
Read out HEX data (as text) from
the EDID assigned/used on the
specified input
Read out native resolution and
refresh rate (English) from EDID
assigned to the specified input.
X(
= 0 = default
Host name
three pairs of MAC address.
DTP2-R-212-xxxxx
.
X2$
= 2 (5 V always output)
Default:
44