Rear Panel Features - Extron electronics DTP2 R 212 Series User Manual

6.
7.
8.
9.
10.
11.

Rear Panel Features

SIG
POWER
OVER DTP2
12V
2
RS-232 IR
3.0 A MAX 1
Tx Rx G Tx Rx
HDMI DTP2 IN
A B C
SIG
POWER OVER DTP2
12V
2 RS-232 IR
2.0 A MAX
1
Tx Rx G Tx Rx
HDMI DTP2 IN
A
B
C
D
E
F
G
Figure 3.
If the transmitting device is in the Extron DTP2 series and you setting up the
•
DTP2 R 212 SA (amplifier model), you can only set the receiver to send power to
the transmitter:
• Set the receiver SEND POWER switch of the receiver (see figure 3,
on page 7) to the "UP" (SEND POWER) position (see
page 10).
• Set the transmitter SEND POWER switch of the transmitter (see figure 3,
to the "DOWN" (OFF) position (see figure 5).
If the transmitting device is in the Extron Legacy DTP series and not the DTP2
•
series, set the SEND POWER switches of both devices to the "DOWN" (OFF)
figure 4
position (see
Connect Over DTP RS-232 and IR control. Connect a serial RS‑232 signal, a
modulated IR signal, or both into this 3.5 mm, 5‑pole captive screw port (see figure 3,
) for bidirectional RS‑232 and IR communication (see
C
Control on page 16 for connection procedures).
Connect control devices. Connect your computer to one of the following ports to
configure and control the device via SIS commands or PCS:
RS-232 port — This 3‑pole RS‑232 port (see figure 3,
•
control (see Display and Remote RS-232 Control
procedures).
Config port — USB mini‑B port for USB control (see
•
Port on page 20 for connection procedures).
• LAN (Ethernet) port — Connect an Ethernet cable for LAN control. LEDs on
the connector indicate link and activity status (see
page 13 for connection wiring).
Power on the output display.
Connect power to the switcher (see
(Optional) Configure EDID Minder (see the DTP2 R 212 PCS Help File).
Power on the source devices.
DTP2 R 212 SA
LINK
SEND POWER
OFF
HDMI
D E F
DTP2 R 212
LINK
SEND
POWER
HDMI
OFF
Power Inlet
HDMI input
OVER DTP2 control
DTP2 IN RJ-45 port
Send Power toggle switch
HDMI output
Audio output
Rear Panel Features
on page 9).
Powering on the Receiver
CLASS 2
4/8 OHM
L R
WIRING
L R
*
G H
L R
Amplified audio output (SA models)
H
Display control
I
Remote amplified volume control (SA models)
J
Switch for volume control (SA models)
K
Remote RS-232 port
L
LAN (Ethernet) port
M
Reset button
N
DTP2 R 212 Series • Installation
E
figure 5 on
Over DTP2 RS-232 and IR
) for serial RS‑232
L
on page 15 for connection
Connecting to the USB
LAN Connector Wiring on
on page 19).
VOL
10V 50mA
DISPLAY
RS-232 RS-232
Tx Rx G Tx Rx G
V C G LAN
* *
I J K L M N
DISPLAY
RS-232 RS-232
Tx Rx G
Tx Rx G LAN
)
E
R
R
7