Table of Contents
Advertisement
E
F
Operations
After the transmitter, receiver, and the connected devices are powered up, the system is fully
operational. If any problems are encountered, ensure all cables are routed and connected
properly.
NOTE: Ensure that the video source and display are properly connected to the FOX3
Configuration and operation of the system is accomplished via
Control
Software
Using the On-Screen Menu System
The OSD menus are used primarily for the initial setup of the device. The on-screen menu
presents configuration options on a local monitor and can be adjusted with front panel
controls.
NOTE: The on-screen menu has a default timeout of 60 seconds.
Menu Selection Buttons
•
•
•
USB 2.0 Host LED — When the transmitter and receiver are connected through
•
the SFP port and a USB 2.0 Host device is connected to the transmitter, the LED
remains lit to indicate an active connected device.
•
USB 2.0 1 LED — When the transmitter and receiver are connected through the
SFP port and a USB 2.0 Host device is connected to the transmitter, the LED
remains lit to indicate an active connected device.
MENU and ENTER buttons (see
access and navigate the on-screen display menu system.
Navigation buttons — Press these buttons to navigate through the on-screen display
menu system or change settings.
transmitter and scaling receiver, and power is applied to the FOX3 transmitter and
scaling receiver and the display before power is applied to the video source. If the
other devices are not turned on before the video source, the image may not appear.
(see page 21), the
Internal Web Page
(see page 32).
MENU button — Press the MENU button (see figure 10,
) to activate or exit the on-screen menu, deselect a
1
submenu, or cancel a pending change.
ENTER button — Press the ENTER button (
CONFIG
to access the on-screen menu, select submenus,
submenu items, or to accept pending changes.
Navigation buttons — Press these buttons to
navigate through the menu system:
•
Press the (Up) (
) or the (Down) (
3
submenu items.
•
Press the (Left) arrow button (
submenu items.
•
Press the (Right) arrow button (
submenu items.
Also use the navigation buttons to adjust settings according to specific setting directions.
FOX3 SR 301 and FOX3 SR 311 Scaling Receivers • Operation
figure 9
on page 12)— Press these buttons to
SIS Configuration and
(see page 41), and
INPUTS
USB
HOST
1
2
)
2
SIGNAL
USB HID
HDCP
USB 2.0
Figure 10.
) arrow button to navigate submenus or
4
) to exit currently selected submenus or
5
) to access currently selected submenus or
6
Configuration
3 3
3
MENU
1
1 1
5
5 5
6
6 6
2 2
2
4
4 4
F
FOX3 SR 301
ENTER
Menu Selection
Buttons
13
Advertisement
Table of Contents
