Table of Contents
Advertisement
212
4-3. Operating the lights and wipers
Pull the lever toward you to the center
position to turn the high beams off.
2
Pull the lever toward you and
release it to flash the high beams
once.
You can flash the high beams with the
headlights on or off.
Cornering lights (if equipped)
When any of the following conditions is
met, while the headlights (low beam)
are on, the cornering lights will addi-
tionally turn on and light up the direc-
tion of movement for the vehicle. This is
to ensure excellent visibility when
either driving at intersections or park-
ing at night.
The steering wheel is operated
The turn signal lever is operated
The shift position is in R (both left
and right side cornering lights)
Cornering light control
■
●
When vehicle speed is approximately 22
mph (35 km/h) or higher, the cornering
lights will not turn on.
●
After the lights remain illuminated for 30
minutes, they automatically turn off.
AHS (Adaptive High-beam
*
System)
*
: If equipped
The Adaptive High-beam System
uses a front camera located on the
upper portion of the windshield to
detect the brightness of the lights of
vehicles ahead, streetlights, etc.,
and automatically controls the light
distribution of the headlights.
WARNING
For safe use
■
Do not overly rely on the Adaptive
High-beam System. Always drive safely,
taking care to observe your surroundings
and turning the high beams on or off
manually if necessary.
■
To prevent unintentional operation of
the Adaptive High-beam System
When it is necessary to disable the sys-
tem: P.229
System controls
According to the vehicle speed, the
brightness and illuminated area of
the high beams are adjusted.
The high beams are illuminated so
that the area around a vehicle ahead
is shaded. (Shaded high beam)
The shaded high beam helps ensure for-
ward visibility while reducing the dazzling
effect on the drivers of vehicles ahead.
Advertisement
Table of Contents
