Lexus RX350 2023 Manual page 217

color, or not aimed properly
• When the headlights are repeatedly
changing between the high beams and
low beams.
• When use of the high beams is inappro-
priate or when the high beams may be
flashing or dazzling pedestrians or other
drivers.
• When the vehicle is used in an area in
which vehicles travel on the opposite side
of the road of the country for which the
vehicle was designed, for example using
a vehicle designed for right-hand traffic in
a left-hand traffic area, or vice versa
• When it is necessary to disable the sys-
tem: P.229
• Situations in which the sensors may not
operate properly: P.234
■ Temporarily reducing front camera sen-
sitivity
The sensitivity of the front camera can be
temporarily reduced.
1 Turn the engine switch off with the fol-
lowing conditions met.
● The headlight switch is in the
position.
● The headlight switch lever is in the low
beam position.
The Automatic High Beam switch is on.
●
2 Turn the engine switch to ON.
3 Within 60 seconds after performing
step 2, push the headlight switch lever
to the high beam position then pull it to
the original position quickly 10 times,
then leave the lever in its original posi-
tion.
4
If the sensitivity is changed, the Auto-
matic High Beam indicator will blink 3
times.
Turning the high beams on/off
manually
Changing to the high beams
■
1 Push the lever forward.
The AHB indicator will turn off and the
high beam indicator will turn on.
4-3. Operating the lights and wipers
Pull the lever to its original position to
enable the Automatic High Beam system
again.
Changing to the low beams
■
1
Press the Automatic High Beam
switch.
The AHB indicator will turn off.
Press the switch to enable the Automatic
High Beam system again.
or
Temporarily changing to the low
beams
It is recommended to switch to the low
beams when use of the high beams is
inappropriate or when the high beams
may cause problems or distress to
other drivers or pedestrians nearby.
1 Pull the lever rearward and then
return it to its original position.
The high beams will illuminate while the
lever is pulled, however, after the lever is
returned to its original position, the low
beams will remain on for a certain amount
217
4