Table of Contents
Advertisement
424
6-1. Maintenance and care
WARNING
Precaution regarding the front and
■
rear bumpers
If the paint of the front or rear bumper is
chipped or scratched, the following sys-
tems may not function correctly. If this
occurs, consult your Lexus dealer.
●
Lexus Safety System + 3
●
BSM (Blind Spot Monitor)
Safe Exit Assist
●
Intuitive parking assist
●
●
RCTA (Rear cross traffic alert)
●
PKSB (Parking Support Brake) (if
equipped)
NOTICE
To prevent paint deterioration and
■
corrosion on the body and compo-
nents (aluminum wheels, etc.)
●
Wash the vehicle immediately in the
following cases:
• After driving near the sea coast
• After driving on salted roads
• If coal tar or tree sap is present on the
paint surface
• If dead insects, insect droppings or
bird droppings are present on the
paint surface
• After driving in an area contaminated
with soot, oily smoke, mine dust, iron
powder or chemical substances
• If the vehicle becomes heavily soiled
with dust or mud
• If liquids such as benzene and gasoline
are spilled on the paint surface
●
If the paint is chipped or scratched,
have it repaired immediately.
●
To prevent the wheels from corroding,
remove any dirt and store in a place
with low humidity when storing the
wheels.
Cleaning the exterior lights
■
Wash carefully. Do not use organic
●
substances or scrub with a hard brush.
This may damage the surfaces of the
lights.
●
Do not apply wax to the surfaces of the
lights.
Wax may cause damage to the lenses.
■
When using an automatic car wash
Set the wiper switch to the off position.
If the wiper switch is in "AUTO", the wip-
ers may operate and the wiper blades
may be damaged.
When using a high pressure car wash
■
When washing the vehicle, do not
●
spray the camera or its surrounding
area directly with a high pressure
washer. Shock applied from high pres-
sure water may cause the device to not
operate normally.
Do not spray water directly on the
●
radar which is equipped behind the
emblem. Otherwise it may cause the
device to be damaged.
●
Do not bring the nozzle tip close to
boots (rubber or resin manufactured
cover), connectors or the following
parts. The parts may be damaged if
they come into contact with high-pres-
sure water.
• Traction related parts
• Steering parts
• Suspension parts
• Brake parts
Advertisement
Table of Contents
