Table of Contents
Advertisement
118
3-2. Opening, closing and locking the doors
If the back door does not fully close due
●
to the operation of the jam protection
function, etc., while the back door is auto-
matically closing after a reserve lock
operation is performed, the reserve lock
function is canceled and all the doors will
unlock.
●
Before leaving the vehicle, make sure that
all the doors are closed and locked.
Close & lock (Walk-Away) function
■
operating conditions
This function can be operated when all of
the following conditions are met:
●
Close & lock (Walk-Away) function is
enabled.
An electronic key is not detected within
●
the vehicle.
●
All of the doors other than the power
back door are closed.
The brake pedal is not depressed.
●
●
The engine switch is off.
●
The electronic key is within the effective
range (detection areas).
Situations in which the close & lock
■
(Walk-Away) function may not operate
properly
In the following situations, the function may
not operate properly:
When the smart access system with
●
push-button start does not operate prop-
erly.
●
When the close & lock function does not
operate properly.
●
When moving away from the back door
while the close & lock (Walk-Away) func-
tion is in the standby state.
Close & lock function
■
tions
This function can be operated when all of
the following conditions are met:
An electronic key is not detected within
●
the vehicle.
●
All of the doors other than the power
back door are closed.
●
The engine switch is off.
*
: This setting can be customized by your
Lexus dealer.
Situations in which the close & lock
■
function
In the following situations, the close & lock
function may not operate properly:
●
If the
power back door (P.112) is pressed by a
hand which is holding an electronic key
If the
●
power back door (P.112) is pressed
when the electronic key is in a bag, etc.
that is placed on the ground
If the
●
power back door (P.112) is pressed
with the electronic key not near the vehi-
cle.
*
: This setting can be customized by your
Lexus dealer.
Hands Free Power Back Door operating
■
conditions (if equipped)
●
The Hands Free Power Back Door (kick
sensor) setting is on.
When an electronic key is carried within
●
the operation range.
■
Situations in which the Hands Free
Power Back Door may not operate
properly (if equipped)
In the following situations, the Hands Free
Power Back Door may not operate prop-
erly:
When a foot remains under the rear
●
bumper
●
If the rear bumper is strongly hit with a
foot or is touched for a while
*
operating condi-
If the rear bumper has been touched for a
while, wait for a short time before
attempting to operate the Hands Free
Power Back Door again.
When standing excessively close to the
●
rear bumper
●
When an external radio wave source
interferes with the communication
between the electronic key and the vehi-
cle (P.127)
*
may not operate properly
switch on the lower part of the
switch on the lower part of the
switch on the lower part of the
Advertisement
Table of Contents
