Edit Cellular Apn1/Apn2 - ZyXEL Communications Nebula LTE3301-PLUS User Manual

Note: This feature is only available on certain models.
Figure 65 Network Setting > Broadband > Cellular APN
The following table describes the labels in this screen.
Table 30 Network Setting > Broadband > Cellular APN
LABEL
APN Settings
#
Enable
Mode
APN
Auth Type
PDP Type
VLAN ID
Modify

7.5.1 Edit Cellular APN1/APN2

On the Cellular APN screen, click the Edit icon next to an APN to configure its settings.
Note: The IP Passthrough fields are not available for models that support the Network Setting >
Broadband > Cellular IP Passthrough screen.
Note: APN information can be obtained from your cellular service provider.
Note: Automatic mode is not supported in all cellular modes.
Chapter 7 Broadband
DESCRIPTION
This is the number of an individual APN.
This field indicates whether the APN is enabled or disabled.
This shows Auto when the Zyxel Device configures the APN (Access Point Name) of a
cellular network automatically.
This shows Manual when the APN is entered manually.
This shows the Access Point Name (APN).
This shows PAP (Password Authentication Protocol) when peers identify themselves
with a user name and password.
This shows CHAP (Challenge Handshake Authentication Protocol) when additionally
to a user name and password, the Zyxel Device sends regular challenges to make
sure an intruder has not replaced a peer.
This shows PAP/CHAP when either type of authentication can be used.
This shows None when no authentication is used.
This shows IPv4 when the Zyxel Device runs IPv4 (Internet Protocol version 4
addressing system) only.
This shows IPv4/IPv6 when the Zyxel Device runs IPv4 and IPv6 (Internet Protocol
version 4 and 6 addressing system) at the same time.
This shows the VLAN ID for the APN.
Click the Edit icon to change the APN settings.
Nebula Mobile Router User's Guide
116