Cellular Sms - ZyXEL Communications Nebula LTE3301-PLUS User Manual

Figure 76 Network Setting > Broadband > Cellular Lock (5G)
The following table describes the fields in this screen.
Table 39 Network Setting > Broadband > Cellular Lock (5G)
LABEL
NR(5G) Lock Management
PCI_Enable
Band
PCI
RFCN
SCS
Cancel
Apply

7.12 Cellular SMS

Use this screen to send and receive SMS messages using the SIM card installed in the Zyxel Device.
Click Network Setting > Broadband > Cellular SMS. The following screen displays.
Chapter 7 Broadband
DESCRIPTION
Click the switch button (to the right) to enable PCI (Physical Cell Identifier) Lock on a
base station when the Zyxel Device has a 5G NR connection.
Enter the band number to which you choose to connect.
Note: Make sure to select the same band in the Network Setting > Broadband
> Cellular Band screen so as the Zyxel Device can connect to that
band.
Use this to enter the PCI number of the base station you want the Zyxel Device to
connect to (0 – 504).
Enter the RFCN (Radio Frequency Channel Number) for the 5G NR frequency of the
specified PCI (1 – 65535).
Select the Subcarrier Spacing (SCS) from the drop-down list. Subcarriers are small signal
carriers that divide a frequency channel, which is the main carrier wave. Subcarrier
spacing is the space between each subcarrier. At the time of writing, SCS ranges from
15-120 KHz.You should select the same SCS that is used by the ISP.
Click this to exit this screen without saving.
Click this to save your changes.
Nebula Mobile Router User's Guide
129