Cellular Apn - ZyXEL Communications Nebula LTE3301-PLUS User Manual

Table 29 Network Setting > Broadband > Cellular WAN (continued)
LABEL
Network
Monitoring
Proxy ARP Feature
Proxy ARP
FQ_Codel Setting
FQ_Codel
APN Manual
Mode
APN
Username
Password
Authentication
Type
PDP Type
Apply
Cancel

7.5 Cellular APN

Click Network Setting > Broadband > Cellular APN to display the following screen. Use this screen to
manage the APNs that Zyxel Device is connected to.
Chapter 7 Broadband
DESCRIPTION
Use this field to allow Zyxel Device to try reconnecting to the base station if the cellular
connection is lost. After the third try, the Zyxel Device will reboot to try to reconnect with the base
station. The LED will blink red to indicate that it is rebooting.
Note: This feature only works if there is a previous cellular connection between the
Zyxel Device and the base station.
Enable this to set your Zyxel Device as a server to handle ARP queries from different subnets. The
Zyxel Device will offer Zyxel Device's own MAC address as an reply.
Select this field to enable FQ_Codel on the Zyxel Device. Clear this field if your network does not
have much real-time traffic.
Use Fair Queuing with Controlled Delay (FQ_Codel) to reduce delays in traffic that could affect
real-time communications, such as video conferencing, live streaming, and voice over Internet
phone calls
FQ_Codel limits traffic throughput, by dropping traffic so as to reduce buffer queuing that causes
delays. It does not prioritize traffic by type.
Disable this to have the Zyxel Device configure the APN (Access Point Name) of a cellular
network automatically. Otherwise, Click this to enable (
field below.
This field allows you to display the Access Point Name (APN) in the profile.
Enter the Access Point Name (APN) provided by your service provider. Connections with different
APNs may provide different services (such as Internet access or MMS (Multi-Media Messaging
Service)) and charging method.
You can enter up to 64 printable ASCII characters. Spaces are allowed.
Enter the user name. You can enter up to 64 printable ASCII characters. Spaces are allowed.
Enter the password associated with the user name above. You can enter up to 64 printable ASCII
characters. Spaces are allowed.
Select the type of authentication method peers use to connect to the Zyxel Device in cellular
connections.
In Password Authentication Protocol (PAP) peers identify themselves with a user name and
password. In Challenge Handshake Authentication Protocol (CHAP) additionally to user name
and password the Zyxel Device sends regular challenges to make sure an intruder has not
replaced a peer. Otherwise select PAP/CHAP or None.
Select IPv4 if you want the Zyxel Device to run IPv4 (Internet Protocol version 4 addressing system)
only.
Select IPv4/IPv6 if you want the Zyxel Device to run both IPv4 and IPv6 (Internet Protocol version 4
and 6 addressing system) at the same time.
Click this to save your changes.
Click this to exit this screen without saving.
Nebula Mobile Router User's Guide
115
) and enter the APN manually in the