ZyXEL Communications Nebula LTE3301-PLUS User Manual page 166

Figure 100 Network Setting > Home Networking > LAN Setup (continued)
The following table describes the fields in this screen.
Table 57 Network Setting > Home Networking > LAN Setup
LABEL DESCRIPTION
Interface Group
Group Name This displays the name of the group that your Zyxel Device belongs to.
LAN IP Setup
IP Address Enter the LAN IP address you want to assign to your Zyxel Device in dotted decimal notation,
for example, (factory default).
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example 255.255.255.0
(factory default). Your Zyxel Device automatically computes the subnet mask based on the
IP address you enter, so do not change this field unless you are instructed to do so.
DHCP Server State
DHCP Select Enable to have your Zyxel Device assign IP addresses, an IP default gateway and DNS
servers to LAN computers and other devices that are DHCP clients.
If you select Disable, you need to manually configure the IP addresses of the computers and
other devices on your LAN.
If you select DHCP Relay, the Zyxel Device acts as a surrogate DHCP server and relays DHCP
requests and responses between the remote server and the clients.
When DHCP is used, the following fields need to be set:
DHCP Relay Server Address
This field is only available when you select DHCP Relay in the DHCP field.
Chapter 9 Home Networking
Nebula Mobile Router User's Guide
166