ZyXEL Communications Nebula LTE3301-PLUS User Manual page 188

Table 65 IP Settings in this Tutorial (continued)
DEVICE / COMPUTER
A
R's N1
R's N2
B
To configure a static route to route traffic from N1 to N2:
Log into the Zyxel Device's Web Configurator in advanced mode.
1
Click Network Setting > Routing.
2
Click Add new Static Route in the Static Route screen.
3
Configure the Static Route Setup screen using the following settings:
4
Click the Active button to enable this static route. When the switch goes to the right (
4a
function is enabled. Enter the Route Name as R.
Set IP Type to IPv4.
4b
Type the Destination IP Address 192.168.10.0 and IP Subnet Mask 255.255.255.0 for the destination,
4c
N2.
Click the Use Gateway IP Address button to enable this function. When the switch goes to the right
4d
( ), the function is enabled. Type 192.168.1.253 (R's N1 address) in the Gateway IP Address field.
Select VDSL as the Use Interface.
4e
Click OK.
4f
Now B should be able to receive traffic from A. You may need to additionally configure B's firewall
settings to allow specific traffic to pass through.
Chapter 10 Routing
IP ADDRESS
192.168.1.34
192.168.1.253
192.168.10.2
192.168.10.33
Nebula Mobile Router User's Guide
188
), the